Door Gaskets
Clean door gaskets every 3 months using same procedures as stated
for interior surfaces. Apply a light film of petroleum jelly to keep
gaskets pliable.
Burn Hazard
Do not touch condenser coils
near defrost pan.
Doing so can result in burns.
Electrical Shock Hazard
Disconnect power or turn
power disconnect switch to
OFF position before removing
top grille. Failure to do so can
result in death or electrical
shock
Defrost Pan
To prevent condensation from overflowing, check defrost pan
periodically. The defrost pan is located behind the kickplate. To
remove defrost pan, remove (4) screws in the kickplate. Clean the pan
and replace.
Door Stop Adjustment
Your unit is factory set at 110° door stop position. To change to either
the ?0° or 120° position, remove door stop pin located in the bottom
hinge using a 3/16" allen wrench. For 120° swing, move pin to utmost
forward stop hole. For ?0° swing, move pin to utmost rear stop.
Changing the light bulbs
Electrical Shock Hazard
Disconnect power at breaker or turn
power disconnect switch to OFF
position before removing a light bulb.
Failure to do so can result in death or
electrical shock
injury or damage,
observe the following:
*Allow light bulb to
cool.
*Wear gloves when
replacing light bulb.
Upper Light Bulb
1. Disconnect power at breaker or turn power disconnect switch to
OFF position.
2. Lightly grasp light cover with both hands and pull down.
3. Replace bulb with an incandescent, medium base tubular bulb with
a maximum of 40 watts.
4. Replace cover by engaging light bracket with the back fingers on
the light cover. Once engaged, snap the front fingers on the light
cover. Note: The clear section of the light cover is considered the
back section.
5. Reconnect power or turn power disconnect switch to ON position.
Door Stop Pin
120,0 90°
22
/ Cover Fingers
Light Cover
23
To Next Page