Viking MB 655 - 12.03 Replacing V-belt pulley

RA_6360_6375_01 - EN
- Engine -
12.02.02 Attaching engine cover
Models with Briggs & Stratton
Quantum engines
• Fit engine cover 1, tighten screws 2
(4 Nm).
2
1
2
Models with Briggs & Stratton
DOV engines
• Fit lower engine cover 1, tighten
screws 2 (4 Nm).
• Clip upper engine cover 3 onto
lower engine cover 1.
12.03 Replacing V-belt pulley
12.03.01 Removing V-belt pulley
Models with blade bushing
- Remove blade bushing
(see section 10.01.01)
Models with blade clutch
- Remove clutch drum
((see section 11.07.01)
12.03.02 Installing V-belt pulley
Models with blade bushing
- Install blade bushing
(see section 10.01.02)
Models with blade clutch
- Install clutch drum
(see section 11.07.02)
99