Viking Professional VCBB363 - Grille Assembly and Installation PBRTGK72 SS

9
GRILLE ASSEMBLY/INSTALLATION
PROFESSIONAL MODEL
PBRTGK72SS
BBeeffoorree mmoovviinngg tthhee rreeffrriiggeerraattoorrss iinn ppllaaccee,, ccoonnffiirrmm tthhee ffiinniisshheedd ddiimmeennssiioonnss,, eelleeccttrriiccaall,, aanndd pplluummbbiinngg llooccaattiioonnss,, mmiinniimmuumm
ddoooorr cclleeaarraanncceess,, aanndd ddoooorr ppaanneell iinnssttaallllaattiioonnss aarree aaccccuurraattee.. ((SSeeee IInnssttaallllaattiioonn I
Innssttrruuccttiioonnss pprroovviiddeedd wwiitthh rreeffrriiggeerraattoorrss))..
1. Position refrigerators in front of cutout.
2. Remove the top air grille assemblies from both of the units
a. Remove full length center grille blade by lifting up and pulling forward.
b. Remove the grille/end cap assembly by removing two (2) screws.
c. Remove grille brackets by removing four (4) screws in each grille assembly.
RREEAARR VVIIEEWW OOFF
GGRRIILLLLEE AASSSSEEMMBBLLYY
TTOOPP VVIIEEWW OOFF GGRRIILLLLEE AASSSSEEMMBBLLYY
72” (182.9 cm)
30 1/32” (76.3 cm)
3 3/8”
(8.6 cm)
4 7/32”
(10.7 cm)
30 7/8“ (78.4 cm)
PPoowweerr
SSwwiittcchh
SShhoowwrroooomm
SSwwiittcchh
3. Verify operation by plugging in
power cord. Power switch
will be shipped in the ON
position and showroom
switch will be in the ON
position. (If showroom switch
is switched to the “OFF”
position, showroom mode is
engaged and power is shut off
to the compressor. This mode
is for showroom display only.)