Viking RDMOR200SS - Product Features and Controls

15
E
Getting Started
Setting the Clock
Before operating your new Microwave Hood make sure you read and
understand this Use and Care Guide completely.
The following steps MUST be taken before any functions can be used.
Before you use the Microwve Hood:
1. Plug in the Microwave Hood.
WELCOME PRESS CLEAR
AND PRESS CLOCK
will appear.
2. Touch the STOP/Clear pad.
:
will appear.
3. Set clock.
To Set The Clock
1. Touch Timer/Clock pad and number 2.
2. Enter the correct time of day by touching the numbers in sequence.
Touch Timer/Clock pad again.
This is a 12 hour clock. If you attempt to enter an incorrect clock time,
ERROR
will appear in the display. Touch the STOP/Clear pad and re-
enter the time.
• IftheelectricalpowersupplytoyourBuilt-inMicrowaveHood
should be interrupted, the display will intermittently show
WELCOME
PRESS
CLEAR AND PRESS CLOCK
after the power is rein-
stated. If this occurs during cooking, the program will be erased. The
time of day will also be erased. Simply touch STOP/Clear pad and
reset the clock for the correct time of day.
Stop/Clear
Touch the STOP/Clear pad to:
• Eraseifyoumakeamistakeduringprogramming.
• Canceltimer.
• StoptheBuilt-inMicrowaveHoodtemporarilyduringtimedcooking.
• Returnthetimeofdaytothedisplay.
• Cancelaprogramduringcooking,touchtwice.