To Next Page
L
Lisa PriceAug 27, 2025
What to do if the igniters will not work on my Viking VURE524G?
- JJohn GarciaAug 27, 2025
Check if the circuit is tripped, a fuse is blown, or if the range is properly connected to power.
What to do if the igniters will not work on my Viking VURE524G?
Check if the circuit is tripped, a fuse is blown, or if the range is properly connected to power.
Why is my Viking Refrigerator not cold enough?
If your Viking Refrigerator isn't cold enough, first, adjust the temperature control to a colder setting and allow 24 hours for the temperature to stabilize. Also, avoid excessive door openings. Make sure the airflow to the front grille isn't blocked. Finally, check the door gasket to ensure it's sealing properly; realign the door or replace the gasket if needed.
How to fix a Viking Refrigerator light that won't turn off?
If the light in your Viking Refrigerator won't turn off when the door is closed, and you have a glass door model, check if the display light is turned on and turn it off. Ensure the appliance is level and the door is aligned correctly so it activates the light switch.
What to do if the Viking Refrigerator ice maker will not operate or ice is not made fast enough?
To ensure your Viking Refrigerator's ice maker operates correctly or produces ice faster: * Check if the on/off lever is in the OFF (up) position; if so, lower it to the ON (down) position. * Verify the water valve is turned on and that water is reaching it; inspect the water line for any leaks. * Make sure the freezer is sufficiently cold by adjusting the temperature controls and waiting 24 hours for stabilization.
What to do if my Viking Ice Maker is not making ice?
If your Viking Ice Maker isn't producing ice, first ensure the On/Off switch is in the correct position. Then, check the electrical breaker to confirm it hasn't tripped. Also, if the “Check Water” light is flashing blue, examine the water supply. The ice maker checks for water every 20 minutes and will automatically restart when the water supply is restored.
What to do if the temperature display on my Viking Refrigerator does not match the set point?
If the temperature display on your Viking Refrigerator doesn't match the set point, it may be because the unit was just plugged in, hot food was recently added, or the door was opened for an extended time or frequently. Allow the unit to stabilize for 24 hours.
Why is there a strong odor when I first use my Viking VURE524G Ranges oven?
If you notice a strong odor and/or smoke when using your Viking Ranges oven for the first few times, this is a normal burn-off of insulation and protective oils. It should disappear after a few uses.
Why is the flame on my Viking VURE524G Ranges burner large and yellow?
If your Viking Ranges burner ignites, but the flame appears large, distorted, or yellow, it could be due to clogged burner ports, using the wrong type of gas, or improperly adjusted air shutters.
Why are the igniters sparking continuously on my Viking VURE524G?
If the igniters on your Viking Ranges are sparking continuously even after the flame has ignited, it could be due to a power supply that isn't grounded, reversed power supply polarity, or wet/dirty igniters.
What to do if igniters sparking but no flame ignition on Viking Ranges?
If the igniters on your Viking Ranges are sparking but there is no flame ignition, it may be due to an interruption in the gas supply. Check that the gas supply valve is in the “ON” position.
General
