22
www.villeroy-boch.com // V 1.0 // 26.04.2018 // V0E100R1
4 Installation requirements
Important
The power and water supplies must be switched off before installation.
•
Make sure that installation has been finished completely before connecting ViClean-I 100 to the power and water
supplies.
•
Make sure that the connection parts of the water supply hose are not damaged.
•
Use ViClean - I100 solely in a line pressure range between 0.1 MPa (dynamic) and 1.0 MPa (static), see
"Technical data", page 20.
•
Use ViClean-I 100 solely in a water temperature range between 10 °C and 35 °C, see "Technical data", page 20.
•
The ambient temperature must be between 15 °C and 40 °C, see "Technical data", page 20.
•
There can be a small quantity of water still inside the product due to the water flow test carried out in the factory.
This water does not, however, constitute a product defect.
Important
These instructions describe the installation of ViClean with ViConnect. If you intend to
use an installation system from another manufacturer, read the respective instructions.
Installation requirements, see page 86.
To Next Page
Loading...
Need help?
General
