12
EnOcean multi-function 1-relay actuator (01796.1)
FUNCTIONALITY
ADDING RADIO ROCKER SWITCHES
The configuration procedure is as follows:
1) Connect the actuator 01796.1 to the electric mains.
2) Press the touch button for 5 s; the LED will blink red, then release the button.
3) To access the actuator acquirement mode, please see the By-me control panel manual. The code sent by the control panel is saved on the
actuator and, to confirm acquisition, the LED will slowly blink green 5 times. If you have exceeded the maximum number of configurable
devices (30) the LED will blink red 5 times.
4) The actuator automatically exits the phase of adding buttons.
REMOVING A RADIO ROCKER SWITCH
A previously saved button can be selectively deleted; this operation is performed using the By-me control panel menus, therefore please see
the relevant manual.
DELETING ALL THE SAVED BUTTONS
To clear all the buttons saved on the actuator, press and hold the touch button for 20 s; in that time the device will go through the various
stages of configuration until the red LED switches on with a steady light, then release the button. Press the touch button again for another 5
s to confirm; the green LED will blink quickly to confirm the deletion of all the saved devices. If the procedure is abandoned, after a timeout of
15 s, the actuator will return to normal operation without deleting anything.
ACTUATOR OPERATION WITHOUT THE BY-ME CONTROL PANEL
CAUTION: Before carrying out the operations to ADD RADIO ROCKER SWITCHES described below, perform the procedure
to DELETE ALL THE SAVED BUTTONS.
ADDING RADIO ROCKER SWITCHES
The pair of rocker switch devices (radio transmitter) and actuator with 1 output (receiver) can also function without the aid of the By-me
control panel and the interface with the EnOcean module; the commands sent via the rocker switches can be received directly by
the actuators.
The configuration procedure is as follows:
1) Connect the actuator 01796.1 to the electric mains.
2) Press the touch button for 5 s; the LED will blink red, then release the button.
3) Then press either the top or the bottom of the rocker switch with which you want to control the actuator. Saving is confirmed by the
LED slowly blinking green 5 times. If you have exceeded the maximum number of configurable devices (30) the LED will blink red 5
times.
4) The actuator automatically exits the phase of adding buttons.
REMOVING A RADIO ROCKER SWITCH
A previously saved radio button can be selectively deleted.
1) Press the touch button for 5 s; the LED will blink red, then release the button.
2) Then press the button you want to remove from the actuator memory; the LED will slowly blink green 5 times. If you have exceeded
the maximum number of configurable devices (30) the LED will blink red 5 times.
3) The actuator automatically exits the phase of removing buttons.
CONFIGURING BUTTON MANAGEMENT
Before you begin saving the buttons in the actuator you can select the type of operation from the following:
• Type 1: Operation as an on/off rocker switch (default setting).
• Type 2: Same as type 1.
• Type 3: Each single button can be saved separately and the load is only active when the button is pressed.
• Type 4: Each single button can be saved separately and the type of operation toggles on pressing the button.
After selecting the type of operation, all the buttons saved in the actuator will have the same behaviour.
To Next Page
Loading...
Need help?
General
