Vimar Elvox 46238.036 - Troubleshooting and Settings; Solutions to Common Problems; Restoring Factory Settings

9
46238.036 - 46239.036
C/

RESET
Online
1
For the alarms (notications) and registrations management, consult the manuals available in the
product sheet at the following internet address: faidate.vimar.com
Solutions to possible problems and advice:
* When conguring the Wi-Fi connection, check the signal strength, keep the video camera as close as
possible to the router.
* If your router allows a 2.4GHz or 5GHz connection, make sure that the smartphone is connected to the
2.4GHz network during the conguration phase.
* If the Wi-Fi conguration has not been successful using the ''Quick Setup'', check that to have correctly
entered the password to connect to the Wi-Fi network (the Wi-Fi connection password eld can not be
left blank).
* If it is necessary to change the settings for another (or new) Wi-Fi network, it is required to reset the
device to the factory default settings (see below).
* After about 30 seconds from the power supply connection, the PT camera 46239.036 will rotate carrying
out a movement test.
* If you forget your password, it is possible to restore the factory default settings and reset it (see below).
* Connection times may be due to the upstream band of the home network (which must be at least 1
Mbps, recommended 2 Mbps.) or to the download band of the mobile device (for a correct operation
the connection must be Wi- Fi or 4G with good coverage).
Restoring the factory settings
Identify the "RESET" button, see image 2 and 4 on page 3 and make sure that the power supply is con-
nected. Press and hold the reset button for at least 30 seconds; when released, the video camera restarts
automatically.
Technical characteristics
Frequency range: 2412-2472 MHz
RF transmission power: < 100 mW (20 dBm)
EN