Vimar ELVOX SL24.T - Advanced Operation and Remote Management; Advanced Calibration Options; Remote Control Programming Guide; Receiver Management Procedures

7
SL24.T
EN
Advanced calibration
(slow-down and pedestrian distance programmed by the installer)
No.
Press
push-button
Step Description
1 - Preparation Move the gate to approximately 1 metre from closing
2 PROG Procedure activation
Press the programming push-button PROG and hold it down; the PRG LED will start ashing slowly;
keep PROG pressed until the PRG LED ashes fast, and then release it
3 51 Gate closing Press pushbutton 51: the motor closes at reduced speed up to the closing limit switch
4 - Gate opening The motor opens at normal speed
5 51
Setting the slow-down
point when opening
Press 51 to set the slow-down starting point when opening the gate
6 - Completion of opening The gate continues until it reaches the opening limit switch
7 - Gate closing The motor closes at normal speed
8 51
Setting the slow-down
point when closing
Press 51 to set the slow-down starting point when closing the gate
9 - Complete closure The gate continues until it reaches the closing limit switch
10 - Gate opening The motor opens at normal speed
11 51
Setting the pedestrian
distance
Press 51 to set the pedestrian opening space
12 - Gate closing The motor closes until the closing limit switch is reached
13 - End of procedure The PRG LED turns o󰀨. End of procedure
Remote control programming
Note: Remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Press push-button
Signal
PRG LED
Description
1 MRX O󰀨 Press the MRX push-button and hold it down until the green PRG LED starts ashing slowly
2 Remote control push-button Slow ashing Press the remote control push-button that you want to save
3 -
Fixed 1 s Button of the saved remote control (new remote control)
3 ashes Memory full
Programming the second radio channel
No. Press push-button
Signal
PRG LED
Description
1 MRX O󰀨 Press the MRX push-button and hold it down until the green PRG LED starts ashing fast
2 Remote control push-button Fast ashing Press the remote control push-button that you want to save
3 -
Fixed 1 s Button of the saved remote control (new remote control)
3 ashes Memory full
Deleting a remote control
No. Press push-button
Signal
PRG LED
Description
1 MRX O󰀨 Press the MRX push-button and hold it down until the green PRG LED starts ashing very fast
2 Remote control push-button Very fast ashing Press the button on the remote control to delete
3 - Fixed 1 s Deletion successful
Complete deletion of the receiver
No. Press push-button
PRG LED indica-
tor
Description
1 - O󰀨 Remove power from the control panel and disconnect any batteries
2 MRX On continuously
Reapply power to the control panel without releasing the MRX button until the PRG LED turns
o󰀨
3 - O󰀨 Receiver deleted completely
After deleting all of the remote controls, the rst one saved congures the control panel to accept only rolling-code or hard-coded remote
controls.