W Series Big Bottle Wine Racks
Installation instructions for WS-BIG1models
Included Parts
• (1) Base strip
• (1) Neck strip
• (6) mounting hole caps
• (2) Plastic Couplers
• (4) Spiral drywall
anchors
• (6) screws
• (2) toggle bolts
Required Tools
• Phillips head screw driver
• Level
Important Note: This installation guide will assist you with installing the VintageView W Series Big Bottle Rack
(WS-BIG1) into wood-backed or drywall surfaces. These models are suitable for most 3L-6L bottle sizes and only
are offered in single-bottle depth conguration.
If installing racks to custom W Series Frames, please use the install guide and hardware included with Frames.
Figure A Figure B
1. CHOOSE BOTTLE DIRECTION
Decide if you want the necks of the bottles facing left or
right, and identify the base from the neck strip (base fea-
tures wider support divots that rest lower on the rack).
2. MARK THE FIRST STRIP
Starting at least 3-1/2” (89mm) from adjacent wall or
other obstructions. Hold the rst Mounting Strip in place
against the wall in desired location (Figure A). Ensure
the Strip is plump using a Level and mark the hole
locations with a Pencil (Figure B). Set the Strip aside.
3. DETERMIN DISTANCE BETWEEN STRIPS
Measure the distance between the bottle’s base and
shoulder and subtract 2” (52mm) to determine the
centerline, or distance from the mounting holes of
one strip to the mounting holes of the next. Most
large format bottles will need between 10”-14”
SCAN THE QR CODE TO FIND YOUR PRODUCT
DOWNLOAD THE FREE APP
3D-GUIDED INTERAC TIVE ASSEMBLY
INSTRUCTIONS CAN BE FOUND ON BILT
®
Before you begin
• Pencil
• Tape Measure
• Drill
• 1/16” (1.6mm) Drill Bit
• 13/32” (10.5mm) Spade Bit
To Next Page
Need help?
General
