Vinten pro-touch Pro-10 System - Page 44

44
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.3 Pro-10 Pan and Tilt Head - RH Side Plate, Tilt Drag and Pan Bar
Item
No.
Part
No. Nomenclature Qty
1 R516-08 Assembly, plate brake 1
2 R503-220 Assembly, friction knob 1
2.1 Boot, tilt drag knob 1
2.2 Nut, M6, standard (hex), full 1
2.3 Knob, tilt drag 1
2.4 Bearing, ball, thrust, 6 mm ID x 14 mm OD x 4.7 mm long 1
3 R516-201 Assembly, right flange 1
4 R516-13 Assembly, tilt balance 1
4.1 Spring, disc, 6.2 mm ID x 12 mm OD x 0.5 mm thick 2
4.2 Stud, tilt drag adjust 2
4.3 Arm, tilt drag adjust 1
4.4 Screw, cap head, socket, M5 x 16 mm long 2
5 R516-206 Assembly, base casting 1
5.1 Assembly, bubble 1
5.2 Assembly, centre housing spares 1
5.3 Screw, low profile, cap head, socket, M6 x 16 mm long 4
5.4 Sleeve, pan bearing 1
6 3219-104 Pan bar 1
6.1 3219-102 Pan bar clamp assembly 1
6.1.1 Pan bar clamp knob assembly 1
6.1.2 Sleeve, insulation, head diameter 18 mm, body diameter 10.9
mm
1
6.1.3 Washer, plain, heavy, M8 1
6.1.4 Pan bar clamp 1
6.1.5 Snap ring, external, standard, 8 mm shaft dia. x 0.8 mm thick 1
6.2 3219-103 Pan bar 1