Vector 750i encoded pantographic pan and tilt head
5
Warning symbols in this
Operators Guide
Where there is a risk of
personal injury or injury to
others, comments appear
highlighted by the word
WARNING!—supported by
the warning triangle symbol. Where there is a
risk of damage to the product, associated
equipment, process or surroundings,
comments appear highlighted by the word
CAUTION!
Usage
The Vector 750i encoded pantographic pan
and tilt head is designed for use by
professional broadcast and film camera
operators, and is ideally suited for use in VR/
AR tracking applications. The head can
support and balance a payload weighing up
to 75 kg (165.3 lbs), and must be correctly
mounted onto equipment designed to
support both the head and its maximum
payload.
Note: For use in VR/AR tracking applications,
the head must be partnered with the Virtual
Reality Interface (VRi) box (product number
V4083-0001, V4083-0002 or V4083-0003),
available from Vinten and Vinten Radamec.
Warning!
1. Do NOT attempt to use
this product if you do not
fully understand how to
operate it.
2. Do NOT use this product
for any other purpose
than that specified in the
Usage statement above.
3. Maintenance beyond that
detailed in this Operators
Guide must be performed
only by competent
personnel.
Disposal of waste batteries
Any batteries included with this product must
not be treated as household waste. By
ensuring these batteries are disposed of
correctly, you will help prevent potentially
negative consequences for the environment
and human health, and help conserve natural
resources. Please view the section on how to
remove the batteries from the product safely.
Hand the batteries over to the applicable
collection point for recycling waste batteries.
Declaration of Conformity
In respect of the following equipment
manufactured by Camera Dynamics Ltd, this
product is manufactured in accordance with
the following EMC standards:
(EMC) Directive 2014/30/EU
FCC
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Disposing of used electrical and
electronic equipment
When you see this symbol on a
product it indicates that this
product must not be disposed of
with household waste. In some
countries or European
Community regions, separate collection
systems have been set up to handle electrical
and electronic waste products. This product
must be disposed of at a collection point for
the recycling of electrical and electronic
equipment. Visit www.vinten.com for more
information.
To Next Page
Loading...
