Vinten Vision 250 E - Page 56

56
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.4 Vision 250 E Pan and Tilt Head - Balance Mechanism
Item
No.
Part
No.
Nomenclature Qty
1 3465-23* Tilt module assembly (with machined from solid drag housing) (Fig 6.6) 1
2 3322-229 Actuator shim 4
3 N500-004 Bearing, needle roller, radial, full complement, 5/16 in. ID x 1/2 in. OD x 5/
16 in. long
2
4 3525-231 Load beam 1
5 M005-706 Screw, skt cap hd, M4 x 16 mm lg 4
6 3465-903SP* Right hand side plate assembly 1
7 3525-283 Balance adjustment stop 1
8 3525-905SP* Adjustment bracket assembly 1
9 P203-012 Bearing, needle roller, radial, 12 mm ID x 16 mm OD x 10 mm long 2
10 3525-232 Pivot block 2
11 N500-024 Bearing, needle roller, radial, full complement, 3/8 in. ID x 9/16 in. OD x 5/
16 in. long
2
12 3525-239 Spring shaft 2
13 3525-282 Balance spring 2
14 3525-280 Spring cap 2
NOTE: the long and short links (Items 15 and 17) are supplied with the appropriate pivot pins (16)
as matched sets and must be replaced in total.
3525-18 Link long assembly, comprising: 1
15 3525-237 Link, long 1
16 3525-286
3525-287
3525-288
Pivot pin "A", AND/OR
Pivot pin "B", AND/OR
Pivot pin "C",
Tot al
2
3525-19 Link short assembly, comprising:
17 3525-238 Link, short 1
16 3525-286
3525-287
3525-288
Pivot pin "A", AND/OR
Pivot pin "B", AND/OR
Pivot pin "C",
Tot al
2
18 3525-270 Potentiometer actuator lever 1
19 M006-904 Screw, countersunk head, socket, M5 x 16 mm long 2
20 3525-271 Potentiometer rod 1
21 3525-16* PCB assembly (Fig 6.8) 1
22 3525-15 Balance knob assembly 1