Viper Responder One - Valet Take-Over

Valet
Take-Over
The
Valet Take-Over feature allows
the vehicle to remain running
after the key has been removed from the ignition.
This
feature
is
useful
for occasions when you wish to exit and
lock
the
vehicle for
short periods
of
time, but
would
like
to
leave
the
motor running
and the
climate controls
on.
To
perform
Valet
Take-Over:
1 . Before turning off
the
engine, press and release
the
single button
once.
The
remote responds with the remote start
ON
tones
and
the
green
LED
on
the
remote
flashes
once.
The
vehicles parking
lights
turn
on constant to confirm remote start operation.
2.
Turn
the
ignition key to the OFF
position.
(The
engine stays running.)
3.
The
engine
runs
until
pre-programmed time
elaps-
es
or a shut-down input
is
received.
(See
the
previous Remote Start
section for a
complete list
of
shut-down inputs.)
Note:
This
feature does not
work
if the brake
pedal
is
being pressed.
10
©
2011
Directed Electronics.
All
rights reserved.