VARIPOOL
20
5.3 Timer setting
You can set up to 4 timers : (hold for 3 seconds to unlock ).
1-Press to enter timer setting.
2-Use
and to choose the first time lap. then press to set the next parameter
(RPM) still using arrows (
and ).
3-Repeat the above steps to set the other 3 timers.
4-Ensure the 4 programs are valid pressing arrows :
or .
• Any overlapping of timer periods will be considered as invalid and the device will only run based
on the previous valid timer setting.
• During timer setting, if you want to abandon it, hold
3 seconds,
5-Press 3 seconds to enter timer settings :
.
Note :
• If inactivate for 1 minute, the screen will lock automatically. Hold on 3 seconds
to unlock.
• The device has power-o memory.
• Under OFF mode, hold for 3 seconds to retrieve factory setting and .
4- To change speed: use buttons while this speed is in use.
5- To change speed or priming time, use following instructions.
In “o” mode press buttons
3 seconds (simultaneously).
Press again to scroll through codes.
CODE Default setting Manual setting
1 priming time 1 mn 0/10 mn
2
3
4
5
6 priming speed 2900 round/mn 1200/2900 round/mn
To Next Page
Loading...