To Next PageTo Next Page
Need help?Do you have a question about the VirtuaPin Plunger Kit and is the answer not in the manual?
General| Type | Plunger Kit |
|---|---|
| Category | Control Unit |
| Connection | USB |
| Compatibility | Pinball machines |
| Material | Metal, Plastic |
Lists required tools for installation, including a screwgun/drill and screwdriver.
Lists required fasteners for installation, including pan head screws and washers.
Identifies the plunger assembly, sensor tube, controller board, harness, and connectors.
Recommends a terminal barrier strip for wiring buttons to the kit.
Mount the board face-up, oriented correctly with headers facing the cabinet side.
Connect the plunger to the indicated connector before powering on the board.
Drill pilot holes for screws to avoid over-tightening and damaging the board.
Details pin assignments for Digital Plunger, Flippers, Magnasave, and other functions.
Details pin assignments for Start Game, Flippers, Magnasave, and service functions.
Plug the cable into the connector and then into your PC for automatic detection.
Nudging is auto-calibrated on power; pull plunger back to calibrate it.
The kit is covered by a 90-day limited manufacturer's warranty for defects.
Tampering, altering, abuse, or improper usage will immediately void this warranty.
Configure button assignments for flippers, plunger, and other game functions.
Configure X, Y, and Z axis assignments for plunger and nudging.
Enable analog nudge and set tilt sensitivity for game physics.
Map game controls like flippers, start game, and insert coin to specific keys.
Map controller buttons to game actions like flippers, nudging, and menu navigation.
Configure analog plunger, nudge, and test roller axis with gain and damping.
