Virutex PEB250 - Page 28

For the PEB250 model:
When the machine has heated up and the granulate has melted,
you with hear a “Beep” “Beep” noise. At this point, turn the
control A (Fig. 14) to position No. 6 and the gluing roller will
start to turn at maximum speed.
For the PEB200 model:
When the machine has heated up and the granulate has melted,
LED C will come on (Fig. 16-1). Press the switch A (Fig. 16-2)
and the gluing roller will start to turn.
To check that the amount of glue being deposited onto the
edge is correct, prepare a strip of the edge that you are going
to use of approximately 1 metre long.
Turn the glue flow control knob A (Fig. 15) clockwise, to the
stop point in the “-“ position (minimum flow).
(Figure 16-1)
(Figure 16-2)
(Figure 15)
A
C
B
A
A
(Figure 14)
E
D
B
C
A
28 - PEB200-PEB250 / Operating instructions