13. ACCESSORY FOR WORKING WITH THE MACHI-
NE SUSPENDED
The machine comes with an accessory for working with the
machine suspended. This accessory must be fixed at the centre
of gravity A (Fig. 23) of the machine as follows:
Place chuck B (Fig. 22) at a distance of 10 mm (approx.) from
the outside of ring A (Fig. 22) and introduce both by fixing
the ring into the threaded hole C (Fig. 22). When chuck A
stops (Fig. 23), finish fastening it in place using a hexagonal
key a/f: 8 mm.
You can suspend the machine using the hole in the ring.
14. NOISE AND VIBRATION LEVEL
The noise and vibration levels of this device have been measured
in accordance with European standard EN 60745-1 and serve
as a basis for comparison with other machines with similar
applications.
15. WARRANTY
All VIRUTEX machines are guaranteed for 12 months from
the date of purchase, excluding any damage which is a result
of incorrect use or of natural and tear on the machine. All
repairs should be carried out by the official VIRUTEX technical
assistance service.
16. RECYCLING ELECTRICAL EQUIPMENT
Never dispose of electrical equipment with domestic waste.
Recycle equipment, accessories and packaging in ways that
minimise any adverse effect on the environment. Comply with
the current regulations in your country.
Applicable in the European Union and in European countries
with selective waste collection systems:
If this symbol appears on the product or in the accompanying
information, at the end of the product's useful life it must not
be disposed of with other domestic waste.
In accordance with European Directive 2002/96/EC, users may
contact the establishment where they purchased the product
or the relevant local authority to find out where and how
they can take the product for environmentally friendly and
safe recycling.
VIRUTEX reserves the right to modify its products without
prior notice.
(Figure 22)
(Figure 23)
A
B
C
B
A
10 mm (max)
A
PEB200-PEB250 / Operating instructions - 39
To Next Page
Loading...
Need help?
General
