29
Viscount UNICORadio Remote Control
The symbol moving on the bottom right indicates that data is being received. When the
process is complete, the following message will appear:
UPLOADING SFTW
SUCCESFULLY
Fifteen seconds later, the system will reboot.
ATTENZIONE
- If you cannot find the REMOTE CONTROL field on the organ display, it might
mean that the receiver of the organ is not properly connected, or that it is not
working.
- After installing the receiver, and each time the organ is switched on thereafter, you
need to press any button on the remote control in order to see the REMOTE
CONTROL screen. Otherwise, the message REMOTE CONTROL NOT PRESENT
will appear. The same error message will also show if the controller is too far
away from the organ or not working.
- While updating the firmware, the update symbol on the remote display might stop:
this means that the controller is not connected to the organ anymore. If the
connection is not resumed in time, the controller aborts the update and shows the
following message:
ORGAN
NOT CONNECTED
please check that the organ is working and the remote control not outside its
maximum range. Should this inconvenient happen frequently, the area might be
subject to electromagnetic or radio interference.
- Should critical verifying/ writing memory errors occur when updating the firmware,
the display will show the following message:
UPLOADING SFTW
SEVERE ERROR
The remote control will reboot in a few seconds. Repeat the update procedure.
Should the same error occur again, please contact our customer service by e-mail
at service@viscount.it.
To Next Page
Loading...
