28
Viscount UNICO Radio Remote Control
REMOTE CONTROL
UPLOADING SFTW *
FIRMWARE UPDATE
Whenever a firmware update is necessary, Viscount will release an update pack, to load on the
organ via USB drive. This procedure is described in the organ user manual.
After the organ has been updated, the new system has to be loaded on the remote control as
well. To do so, access the MIDI & UTILITY menu of the organ, then select the REMOTE
CONTROL function:
The CURR. VER. field indicates the firmware version currently installed on the remote control,
while the NEW VER. indicates the latest one. Press [EXIT] to abort the procedure, or
[ENTER] to start updating the remote control. The following screen will show:
Now press and hold the [STOP] button on the remote control:
OpSys Ver. 1.00
Tx Channel: 7
Then press either [SONG PREV.] or [SONG NEXT]. The controller is now receiving the
firmware update.
To Next Page
Loading...
