Viscount unico series - How to Select and Play a MIDI Sequence; Selecting MIDI Tracks by Index; Navigating MIDI Tracks

24
Viscount UNICO Radio Remote Control
HOW TO SELECT AND PLAY A MIDI SEQUENCE
In order to play a MIDI sequence, first load the desired .MID file. Please remember that these
files are saved in an USB drive or inside the internal memory of the organ, in the
nnn_songname.mid format; “nnn” stands for the three digits automatically set by the organ,
that from now on will be called “index”.
To select a .MID file remotely, dial the three index digits. However, although each MIDI file
has a three-digit index, it is not always necessary to dial them all on the remote: you can
- dial all the digits, if the track index is a number larger than 099 (e.g. press [1] – [2] – [3] for
123)
- dial two digits, when the index is between 010 and 099 (e.g. [1] – [6] for 16)
- dial one digit, when the index is between 000 and 009 (e.g. [8] for 8).
The dialled digits will appear on the bottom left of the screen.
ú-26 óg5 ý
¢§
After dialling the index, the system will take a few seconds to search and load the MIDI file on
the sequencer. If it works correctly, the file name will appear on the screen:
ú-26 óg16 ý
_CONCERT1 Ý
N.B.
If you dial a wrong index (or, at least, the index of a MIDI file which is not on the
currently active memory) the screen will show the following message:
ú-26 óg5 ý
SongNOPresent
The track can also be selected by pressing the [SONG PREV.] (previous song) and [SONG
NEXT] (next song) buttons. Previous and next always refer to the song’s index.
Whenever no .MID file has been selected yet, [SONG PREV.] will select the file with lowest
index number. [SONG NEXT] will select the song with higher index number instead.