Viscount unico series - How to Install the Remote Receiver Inside the Organ; Step 5: Connecting Receiver to Organ CPU; Finalizing Installation and Initial Check

33
Viscount UNICORadio Remote Control
8. Place the back panel back in position.
WARNING
After installing the receiver, and each time the organ is switched on thereafter, press
any button on the remote control to show the REMOTE CONTROL screen on your
organ display. Otherwise, the organ will show the error message REMOTE CONTROL
NOT PRESENT, as if the remote were not available, either too distant or broken.
7. Link the flat cable to the CN1 connector of the remote receiver and to the CN28 RF
MODULE connector of the organ CPU. Before you insert the connectors, place the flat
cable together all the other electric wires between the CPU board and the circuits on the
right side of the organ (looking the organ from behind). Bind the wires with the cable ties
already inside the instrument.
CN28
RF MODULE
CN1
Flat cable