UHI/MHI Connector & Cradle
3. Inserting MB-2 into UHI/MHI Connector
MB-2 is designed to work with pre-installed UHI/MHI system in your car. Therefore, you will
need to locate the UHI/MHI connector which can normally be found in the tray under the front
armrest.
If there is a phone cradle attached to the UHI/MHI connector please
removes it before connecting your MB-2 to the UHI/MHI connector.
To remove the cradle:
1. Make sure your engine is off.
2. Press the release button on your cradle (normally located at the top).
3. Remove the cradle from UHI/MHI connector with care.
Now insert your MB-2:
1. Make sure there is no cradle attached to the UHI/MHI connector
2. Gently slides the MB-2 (UHI socket side facing downwards) onto
the UHI/MHI connector until it locks into the connector.
To Next Page
Loading...
