Date of last revision: 9.05 TREADMILL.CALIB.TM181.TC17305.REV1
STEP 1 EnTEr EnginEEring ModE
• With the SAFETY KEY in place, hold the “ELEVATION UP” and “sPEEd
dOwN”
buttons for 5 seconds. The profile window will read “DGA3J”
and the function window will read “NONE”.
• Use the elevation keys until “ENG1” is displayed in the function window.
Press “sELECT”. You are now in ENGINEERING MODE.
STEP 2 SET MiniMuM SPEEd
• Press the “ELEVATION dOwN” button until the function window reads
“P0”. “0” will appear in the elevation window and “39” should appear in
the speed window. To adjust, press “sTART”.
• Press the “sPEEd UP” or “sPEEd dOwN” button until the elevation
window reads “35 - 41”. The running belt should be moving at .5 MPH.
• Press the “sELECT” button to update the data.
STEP 3 SET MaxiMuM SPEEd
• Press the “ELEVATION UP” button until the function window reads “P1”.
“0” will appear in the elevation window and “418” should appear in the
speed window. To adjust, press “sTART”.
• Press the “sPEEd UP” or “sPEEd dOwN” button until the elevation win-
dow reads “415 - 425”. The running belt should be moving at 12 MPH.
• Press the “sELECT” button to update the data.
STEP 4 SET ThE half MaxiMuM SPEEd
• Press the “ELEVATION UP” button until the function window reads “P2”.
“0” will appear in the elevation window and “216” should appear in the
speed window. To adjust, press “sTART”.
• Press the “sPEEd UP” or “sPEEd dOwN” buttons until the console
reads “210 - 220”. The running belt should be moving at 6 MPH.
• Press the “sELECT” button to update the data.
T9500 (TM181) Deluxe (TC17305)
Calibration Guide
CALIBRATION GUIDES
1
To Next Page
Need help?
General
