How to troubleshoot no sound on Vision AV-1500?
If your Vision Amplifier isn't producing any sound, start by turning it off and checking all connections to ensure they are secure. Also, verify the output level from your audio sources, such as checking the volume level on your laptop.
Why is my Vision Amplifier sound distorted?
If you're experiencing distortion with your Vision Amplifier, it could be due to the volume being too high. Alternatively, the loudspeakers may be worn or damaged.
What to do if Vision AV-1500 sound only coming out one side?
If sound is only coming from one side of your Vision Amplifier, you can try the following: * Adjust the balance control. * Turn off the amplifier and switch the output connections; if the side changes, the amplifier itself is likely okay. * Switch the input connections and check the input cabling.
Why Vision AV-1500 Amplifier has no power light?
If the power light on your Vision Amplifier is not illuminated, check the power connections first. If the issue persists, it could be due to an abnormal load. In this case, turn the power off, disconnect some speakers, and test again.
How to stop feedback on Vision Amplifier?
If you're experiencing feedback with your Vision Amplifier, turn down the microphone volume or move the microphone further away from the speakers.
Caution to reduce risk of electric shock, do not remove cover. Refer servicing to qualified personnel.
Exclamation point indicates important operating and maintenance instructions.
Do not expose appliance to rain or moisture to reduce risk of fire or electric shock.
Check connections, output levels from sources (e.g., laptop volume).
Check power connections, potential abnormal load. Disconnect speakers and test.
Check if volume is too high or if loudspeakers are worn or damaged.
Turn microphone volume down or move microphone away from speakers.
General| Channels | 2 |
|---|---|
| Total Harmonic Distortion | <0.05% at rated power |
| Inputs | RCA |
| Outputs | Binding posts |
| THD | <0.05% at rated power |
| Type | Stereo Power Amplifier |
| Speaker Impedance | 4-8 Ohms |
To Next Page
