10. User Operation
10.1 Change the User Code
Change the user code by card
Press * Read card Old code # New code # New code #
Note: The default code “1234” of matching card can’t open the door unless revising other codes.
Change the user code by fingerprint
Press * Input fingerprint Old code # New code # New code #
Note: The default code “1234” of matching fingerprint can’t open the door unless revising other codes.
Change the user code by ID number
Press * ID number # Old code # New code # New code #
Note: ID number has to be known from admin before changing the code, user code can’t be default code “1234”.
11
Other Operation
11.1 Remove Alarm
Read admin card or Read valid user card or Input valid fingerprint or Press admin code #
Note: When the alarm is activated, user can remove the alarm by reading a valid card or Input valid fingerprint or pressing
valid admin code .
11.2 Reset to Factory Default
Use
rs can reset to the factory default when the admin code is forgotten, or the default settings have been modified,
operation as below:
Power off, press and hold the # key or the exit button continuously, power on, release the # key or the exit button until
hearing beep sound twice, the admin code has been reset to 999999, factory default settings are successful.
Note: Registered user data won’t be deleted when reset to factory default.
Technical support * 2023
To Previous Page
Loading...