Visonic MAESTRO-1600 - Page 3

DE5110 3
• Momentary action Keyswitch
(option): If one of the zones is
defined as a "keyswitch zone", you may install a keyswitch for
arming/disarming the system (in the AWAY mode only).
 6\VWHP &RQILJXUDWLRQV )LJ 
An alarm system based on the MAESTRO-1600DL must include,
as a minimum, the units which are shaded in Fig. 1.2. Each
optional unit (shown in dotted lines) contributes additional
capabilities to the alarm system.
Various detectors must be wired to the control module's zone
inputs, same as in any other alarm control panel. The detectors
are not shown in the diagram, but their existence is suggested by
the zone loop circuits.
A .
All servicing should be undertaken by qualified services
personnel.
B .
Electrical wiring must comply with the local standards and
regulations that are valid at the time of installation.
C .
Do not perform service or repair operations unless the mains
power supply to the control panel is cut off by the circuit
breaker.
Figure 1.2 MAESTRO-1600DL, System Block Diagram
63(&,),&$7,216
 *HQHUDO 'DWD
Number of Zones: 8 or 16 (with expander), programmable
attributes.
Programmable Zone Types: Instant, delayed type 1, delayed
type 2, follower type 1, follower type 2, 24 hours (bell), 24 hours
(bell/ buzzer), fire, keyswitch.
Additional Zone Attributes: Priority, Perimeter, Chime, Silent
Alarm Loop Type: End-of-Line (E.O.L.), 10 kΩ
Control Facilities: Installer code, master code, 6 users codes and
one "maid code" - 4 digits each. Keyswitch option also available.
Download/Upload: Full control and data download/upload from a
remote computer; partial control from a remote DTMF telephone.
Arming Modes: AWAY, HOME, AWAY-INSTANT and
HOME-INSTANT
Disarming Modes: Regular or "ambush"
Emergency Pushbuttons: Quick-action keys A, B and C
Alarm Types: Silent or bell/buzzer, as programmed
Audible Alarm Modes:
Continuous (initiated by all zones except for fire zones)
Pulsating (initiated by fire zones only).
Bell/Siren Timeout: Programmable, 1 to 99 minutes. If the zone
remains open, the alarm renews 30 seconds after timeout. The
number of alarm renewals is also programmable (1 to 99 times).
Exit Delay: Programmable, 0 to 99 seconds