Visonic MC-302V PG2 User Manual

D-304535 MC-302V PG2 Installation Instructions 1
1. INTRODUCTION
The MC- 302V PG2 is a very thin PowerG
magnetic contact device that is compatible
with PowerMaster control panels. The device
includes a built- in reed switch (that opens
upon removal of a magnet placed near it).
The MC- 302V PG2 sends the alarm
message to the control panel using PowerG
2- way communications protocol. A periodic
supervision or alarm message is transmitted
automatically. The control panel is thus
informed, at regular intervals, of the unit’s
active participation in the system.
The LED lights green/yellow/red, according
to signal strength, upon first insertion of the
battery and for the test period of 15 minutes.
Operating power is obtained from an on-
board 3 V Lithium battery. When the battery
voltage is low, a “low battery” message is
sent to the receiver.
The MC- 302 V is available for 433 MHz, 868
MHz, and 915 MHz.
A. Transmission LED B. Magnet
Figure 1: External View
2. INSTALLATION
2.1. Mounting
Caution! This equipment shall be installed by Service Personnel in non-hazardous indoor locations only.
A. Enroll button B. Double-sided adhesive tape
Figure 2: Mounting
MC-302V PG2
Supervised Vanishing Magnetic Contact Device
Installation Instructions

Visonic MC-302V PG2 Specifications

General

Brand	Visonic
Model	MC-302V PG2
Category	Security System
Language	English

Summary

Introduction to the MC-302V PG2 Device

MC-302V PG2 Installation and Enrollment

Mounting Instructions

Details the physical mounting process for the magnetic contact device and its magnet.

Device Enrollment Procedure

Outlines the steps for enrolling the device into the PowerMaster control panel system.

MC-302V PG2 Testing and Diagnostics

Local Diagnostics Test

Explains how to perform a local test to verify detection and signal strength.

MC-302V PG2 Compliance and Standards

FCC and IC Compliance

Details FCC and IC compliance statements, including interference and RF exposure guidelines.

Reed Switch Performance

Explains reed switch activation distances for wood and iron surfaces based on axis.

MC-302V PG2 Technical Specifications

Device Specifications

Provides detailed technical specifications including frequency, power, battery, and dimensions.

MC-302V PG2 Warranty and Recycling

Product Warranty Information

Details the terms, conditions, and limitations of the product warranty.

WEEE Recycling Declaration

Provides instructions for proper recycling of the electronic equipment.