Visonic MCT-320 SMA - Mounting the MCT-320 SMA Sensor; Magnet Mounting Procedures; Transmitter Mounting Procedure

2 D-303359 MCT-320 SMA Installation Instructions
4. MOUNTING
NOTE: It is highly recommended to attach the transmitter to the top of the door/window on the fixed frame and the magnet to the movable part (door or window).
Make sure that the magnet is located not more than 6 mm (0.25 in.) from the transmitter’s marked side.
The transmitter should be mounted on the fixed surface and the magnet on the moving surface (see Figure 1).
Magnet Mounting
2
A. Fasten the spacer to mounting
surface with 2 serews.
B. Locate the magnet on the spacer at
the correct direction and push it upwards
.
1
Remove
spacer
Magnet
3 mm
spacer
3
mm
s
p
a
c
e
r
Fig. 2 – Magnet Mounting
Magnet Mounting with Optional Spacer(s)
Optional spacer(s), 3 mm width, 7mm with, or both, can be used for the magnet mounting.
1
Join the
2 spacers
3 & 7mm
spacers
mounting
7m
m
s
p
a
c
er
3m
m
s
p
ac
er
2
Fasten
Magnet with
3mm spacer
Magnet with
7mm spacer
Magnet with
3 & 7mm
spacers
Fig. 3 – Magnet Spacers
Sensor Mounting
3
2
Fasten the bracket with 3 screws
Locate and push the
transmitter on the bracket
1
Push screwdriver #2
on the “stair” and turn the
screwdriver clockwise to
separate the transmitter from
its bracket
Fig. 4 – Transmitter Mounting