Visonic SR-730 PG2 - 4. SR-730 PG2 Device Settings Configuration; Siren Configuration Parameters

D-302414 SR-730 PG2 Installation Instructions 3
5.
Here you determine whether or not to activate the exit – entry beeps, and if enabled,
whether to activate in HOME or AWAY mode.
6.
7.
or
Select between "Disabled", "Disabled _ Home" and "Enabled".
8.
9.
Here you determine whether or not to activate the squawk, and if enabled, whether to
activate the sounder only, the strobe only, or, the sounder and strobe simultaneously.
10.
11.
or
Select between "Disabled", "Sounder only", "Strobe only" and "Sounder+strobe".
12.
13.
Here you determine the volume level of the sounder.
14.
15.
or
Select between "Volume HIGH", "Volume LOW" and "Volume MID".
16.
Note: For UL Listed product, set to “Volume HIGH”.
17.
Here you determine whether or not the LED will be activated to indicate that the siren is
operating.
18.
19.
or
Select between "Disabled", and "Enabled".
20.
21.
Here you determine whether or not the siren alone will sound a tamper alarm when there is
no communication between the siren and the control panel.
22.
23.
or
Select between "Disabled" and "Enabled".
24.
When exiting " INSTALLLER MODE " menu, the alarm system displays the number of
devices that need to be updated, as follows: " DEV UPDATING NNN ".
For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and
Defining Defaults see the control panel Installer Guide.
A
UTO TAMPER ALRM
D
isabled

A
UTO TAMPER ALRM
A
CTIVITY LED
D
isabled

A
CTIVITY LED
S
OUNDER VOLUME
V
olume HIGH

S
OUNDER VOLUME
S
QUAWK
D
isabled

S
QUAWK
E
XIT
-
E
NTRY Beeps
D
isabled

E
XIT
-
E
NTRY Beeps
S
TROBE ALARM