Please contact 1-855-847-7264 for further assistance.
Pre-operation (continued)
PREPARING THE ENCLOSURE
Gloves and safety goggles should be worn during installation.
It is not recommended to install the appliance into a corner or directly beside a wall. The cooler door will need to be
opened more than 90° to allow full extension of the shelves. If it is necessary to place next to a wall or in a corner,
leave at least 2-4 inches (5-10 cm) of space between the wall and the appliance to allow for the door opening.
The cabinet opening must be at least 24 inches (61 cm) wide by 35 inches (88.9 cm) high by 25 inches (63.5 cm) deep.
If the electrical outlet is located inside adjacent cabinetry, cut a 1.5 inch (3.8 cm) diameter hole to admit the power cord.
If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.
□
□
□
□
5
HOMEDEPOT.COM
NOTE:
The listed depth requirement is assuming that the electrical outlet is
located in the adjacent cabinetry or ush mounted in the rear wall, not
surface mounted inside the enclosure.
*If electrical outlet in
adjacent cabinetry
35 in.
(88.9 cm)
2 in. (5 cm)
6 in.
(15.2 cm)
1.5 in. (3.8 cm) diameter
24 in. (61 cm)
Electrical Access
90°
25 in.
(63.5 cm)
To Next Page
Loading...
Need help?
General
