Need help?Do you have a question about the vita Vacumat 300 and is the answer not in the manual?
General| Brand | vita |
|---|---|
| Model | Vacumat 300 |
| Category | Medical Equipment |
| Language | English |
Controls for powering the furnace and adjusting the firing tray lift.
The main screen and multi-function keys for navigation and program selection.
Buttons used to begin a firing program or to halt operations.
Keypad for entering program numbers and parameter values.
Lists adjustable settings like standby temperature, display brightness, and language.
Settings for pre-drying, rise time, hold time, and final temperature.
Configuration of vacuum pump operation and cooling phases during firing.
Describes preheating restoration with flux and solder at 400°C for 15-20 mins.
Describes preheating restoration with flux but no solder at 400°C for 15-20 mins.
Details factory calibration settings for VITA Spectra-Seal including temperature and times.
Details factory calibration settings for VITA Metal-Corrector including temperature and times.
Procedures for refractory dies and spacers in VITA Hi-Ceram systems.
Firing parameters for core build-ups and cervical porcelain layers.
Steps for oxydizing platinum foil and performing various glaze firings.
To Next Page
