How to fix 'CORRUPT DATA' message on my Vitamix Blending Station Advance display?
To fix a 'CORRUPT DATA' message on your Vitamix Blender display, turn the machine off, and then on again. This will reset the programming.
Explains the basic settings of the six Pre-Set buttons for common drinks.
Provides guidance on placing ingredients and using the machine for optimal results.
Offers advice on how to maintain the blender and prevent damage.
Details how to customize pre-set buttons with specific recipes.
Explains the process of loading custom programs via a chip.
Provides steps to revert pre-set buttons to factory default settings.
Instructions for removing and reinstalling the cover door.
Important notes regarding container compatibility and usage.
Steps for removing and replacing the back cover.
Describes the two-piece and one-piece lids for the container.
Details the blade assembly, its removal, and replacement.
Instructions for installing the machine in a counter.
Steps for preparing the counter area before installation.
Guidance on how to install the gasket for the In-Counter model.
Lists recommended cleaning agents, rinse aids, and destainers.
How to safely clean the motor base and control panel.
Recommended cleaning and sanitizing procedures for container and blade.
Addresses issues like loud noise, non-spinning blades, and leaks.
Explains meanings of error messages like 'CORRUPT DATA' and 'THERMAL SENSOR FAILURE'.
Instructions for handling motor overheating and shutdown.
Simple maintenance tips to maximize the life of the blender.
Details what is covered under the warranty for motor base and components.
Lists conditions and situations not covered by the warranty.
Information on how to contact Vitamix for service and repair.
Details voltage, frequency, and amperage for the machine.
Provides height, depth, and width measurements for on-counter installation.
Provides measurements for in-counter installation, including depth below counter.
To Next Page
General