vitapur VWD1086BLS-PL

Questions and Answers

J
jessicariceAug 3, 2025
Why is my Vitapur Water Dispenser not dispensing water?
- A
  Anthony FordAug 3, 2025
  Your Vitapur Water Dispenser might not be dispensing water due to several reasons. It could be an empty water bottle – replace it with a full one. Mineral deposits might be clogging the tanks, so refer to the 'Cleaning the Reservoirs' section. There might be an air pocket, so push down the dispenser buttons to prime the unit. Finally, check if the child safety lock (for hot water) is activated, and deactivate it if it is.
C
Cory GomezAug 12, 2025
Why is my Vitapur Water Dispenser water not hot or cold enough?
- R
  rebecca19Aug 12, 2025
  There could be several reasons why the water from your Vitapur Water Dispenser isn't hot or cold enough. First, if all the water in the tank has been used, replace it with a full bottle and wait for the water to cool and heat; you can also adjust the cold water temperature control to a colder setting. Ensure the unit is plugged into the outlet and that the hot water power switch at the back is activated. Check your home's circuit breaker or fuse. If the temperature limit has tripped, allow the hot water tank to cool for 15-30 minutes to reset automatically. Make sure the lower front panel is installed for proper operation. Finally, adjust the cold water control to achieve the desired temperature.
T
Theodore AllenAug 22, 2025
What to do if my Vitapur Water Dispenser is leaking?
- G
  gregory08Aug 22, 2025
  If your Vitapur Water Dispenser is leaking, it's likely that the drain cap and silicone seal are not secure. Make sure the seal is correctly placed in the drain plug and tighten the drain cap to secure it.

Summary

Safety Information

Pre-Operation

Grounding Precautions

Safety guidelines for electrical grounding.

Electrical Requirements

Specifies the necessary electrical supply for the dispenser.

Specifications

Details the model's physical and performance characteristics.

Package Contents

Lists all components included with the water dispenser.

Initial Product Cleaning Procedure

Step-by-step guide for cleaning the dispenser before first use.

Installing the Water Bottle

Instructions for properly placing a water bottle onto the dispenser.

Warranty

Control Panel LED Light Functions

Operation

Dispensing Cold Water

How to dispense cold water from the unit.

Adjusting the Temperature (Cold Water Only)

Guide to modifying the cold water temperature setting.

Dispensing Hot Water

Instructions for dispensing hot water, including safety notes.

Care and Cleaning

Cleaning the Outside of the Water Dispenser

Steps for cleaning the exterior surfaces of the unit.

Cleaning the Drip Tray

Instructions for removing and cleaning the drip tray.

Cleaning the Condenser

Procedure for cleaning the condenser coil for optimal performance.

Draining the Reservoirs

How to empty the internal water reservoirs.

Going Away On Vacation

Drinking Straw Instructions

Troubleshooting

vitapur VWD1086BLS-PL Specifications

General

Heating Power	420W
Voltage	120V
Type	Bottom Loading
Water Temperature	Hot and Cold
Features	Child Safety Lock
Capacity	3 or 5 gallon bottles
Material	Stainless Steel
Color	Black/Stainless Steel