EasyManua.ls Logo

Vitek VT-1652 - Installation and Settings; Grounding Requirements; Initial Setup Procedures

Vitek VT-1652
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
ENGLISH
Carefully touch the tested cookware, if it is hot, but the water in the glass is cold, do not use this
cookware for cooking in the microwave oven.
Do not exceed testing time. Maximal time is 30 seconds.
Cookware Usage in the microwave oven
Heat-resistant glass Yes
Non-heat resistant glass No
Heat-resistant ceramics Yes
Plastic cookware for microwave oven Yes
Food paper Yes
Metal tray No
Metal grate No
Aluminum foil or containers from foil No
TIPS ON GROUNDING OF THE MICROWAVE OVEN
The unit should be securely grounded. In case of any short circuit grounding reduces risk of getting
electric shock, because current will pass via a ground wire. A power cord with a grounding wire and the
plug with a grounding contact are used in the unit. The plug should be connected to the outlet that should
always have a grounding contact.
For additional protection you can install a residual current device with nominal current of operation, not
exceeding 30 mA into the mains of the microwaves oven, when installing, contact a specialist.
WARNING: usage of the plug with a grounding contact connected with the outlet without grounding can
lead to the risk of electric shock. Consult a qualified electrician, if you do not understand the instructions
on grounding or if you are not sure that the unit is securely grounded.
To prevent tangling of the power cable the unit is equipped with a short power cable.
If you need an extension cord use only a 3-wired extension cord with a grounding contact on the plug and
the socket.
- Marking of the cord wire section of the microwave oven and on the cable of the extension cord should
match.
- There should be a grounding wire in the extension cord.
- The power cable of the extension cord should not hang over the edges of the table, where children can
pull it and it should not be in a passing way.
SETTING
Before switching on the unit, make sure that the voltage in your home socket corresponds to the
voltage specified on the unit.
Make sure that all packing materials are removed from the oven chamber.
Do not remove a light-gray mica base inside the chamber in the place of microwaves output (6),
as it serves to protect the magnetron.
ATTENTION! Make sure that the unit does not have damages such as: bent or broken door, broken
or loose hinges and latches, dimples inside the oven or on the door. With the existence of any of the
damages, usage of the unit is prohibited.
Set the unit on the flat stable surface that will bear its weight and max. weight of the products,
which will be cooked in it. Place the unit out of the reach of children.
Do not place the unit in places with high moisture and temperature, and near inflammable
objects.
Proper ventilation is needed for normal operation of the unit. Set the oven leaving at least 7-8 cm
of space behind and on the sides of the oven and 30 cm of space above the oven.
VT-1652 BELORUS.indd 6VT-1652 BELORUS.indd 6 09.08.2011 17:17:5209.08.2011 17:17:52

Related product manuals