7
ENGLISH
Do not block ventilation openings on the microwave oven case. Do not remove supporting legs •
from the bottom of the oven.
Do not use the unit without the glass tray and the roller ring.•
Make sure that the power cable does not have any damages and does not pass below the unit or •
through any hot or sharp objects.
MICROWAVE OVEN ASSEMBLY
Remove the package and the accessories from the operating chamber. Check the oven whether there is
deformation or not. Pay special attention to the door state. If there is some problem do not set and do not
switch on the oven.
Protective covering
Case: If there is protective covering, remove it from the surface.
Do not remove light grey mica plate inside the operating chamber at the place of microwaves
output (6); it serves to protect the magnetron.
Setting the glass tray
Set the rotating socket (4) in the opening situated on the bottom of the operating chamber. •
Set the roller ring (5) on the bottom of the chamber. •
Carefully set glass tray (3) on the roller ring (5), by matching ledges and grooves of the support (4).
•
Never set the glass tray with its bottom upside down. •
Do not prevent rotation of the glass tray while operating the oven. •
During cooking always use glass tray and tray support. •
Cookware should be always set only on the glass tray. •
The glass tray can rotate clockwise/anti clockwise. It is normal. •
If cracks or chops appear, stop using the unit immediately or replace the glass tray. •
OPERATION
Before switching on the unit, make sure that the voltage in your home socket corresponds to the •
voltage specified on the unit.
1. Setting time
When the unit is connected to the mains, you will hear a sound signal and “0:00” will appear on the display.
You can set time in the range 0:00 - 23:59.
Press the (13) 1. “Clock/Presets” button, flashing “0:” will appear on the display.
Turning the knob (16), set “hours”.2.
Press the (13) 3. “Clock/Presets” button, flashing “:00” will appear on the display.
Turning the knob (16), set “minutes”.4.
Press the (13) 5. “Clock/Presets” button, to finish time setting. The preset time will appear on the display
and symbol (:) will be flashing.
Note
- If clock is not set, the current time will not be displayed.
- If you incorrectly input the current time, press the (14) “Stop/Cancel «button to reset the values and
repeat points 1-5.
2. Cooking in a microwave oven
Select the power level of the microwave oven and set the time.
Open the door, put products into the operating chamber and close the door.1.
Press the (11) 2. “Microwaves/Grill/Combi” button, you will hear a sound signal, “Р-100” will be flashing
on the display.
VT-1652 BELORUS.indd 7VT-1652 BELORUS.indd 7 09.08.2011 17:17:5309.08.2011 17:17:53
To Next Page
Loading...
