EasyManua.ls Logo

Vitek VT-2433 - Maintenance and Storage; Technical Specifications and Compliance

Vitek VT-2433
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
ENGLISH
Important: Do not put the iron on the steam sta-
tion base during the self-cleaning to avoid getting
moisture on furniture.
AFTER USE
Install the iron on the corresponding tray of the
base (1).
Press the lock of the iron (4), to properly secure
it on the base.
Remove the water tank and drain any remaining
water from it.
Allow the iron to fully cool down before cleaning,
moving, or taking it away for storage.
You can fold the connection hose in half and put
it into the storage (11) in the base.
The water tank should be empty when storing
the steam station vertically.
MAINTENANCE AND CARE
Unplug the base block and allow the unit to fully
cool down.
Wipe the outer surfaces with a wet cloth. Use
some detergent, if necessary.
Remove stains and mineral deposits from the
iron soleplate using a cloth soaked in a water-
vinegar solution, then wipe the surface of the
soleplate with a dry cloth.
Be careful not to scratch the soleplate.
Do not use abrasives or any solvents to clean the
steam station base or the iron.
STORAGE
Make sure that the steam station has fully cooled
down before taking the unit away for storage.
Drain any remaining water from the water tank (2).
Clean the unit, as described in the «MAINTE-
NANCE AND CARE» section.
Coil up the connecting hose and store it in the
designated area at the base.
Store the unit in a dry, cool, and darkened place,
unreachable by children and people with dis-
abilities.
DELIVERY SET
Steam station – 1 pc.
Manual – 1 pc.
Warranty certificate – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220-240 V ~ 50-60 Hz
Rated power consumption: 2200 W
Pressure: 4 bar
Maximum steam release: 140 g/min
Water tank capacity: 1.3 L
RECYCLING
For environment protection do not throw out the unit
and the batteries (if included), do not discard the
unit and the batteries with usual household waste
after the service life expiration; apply to specialized
centers for further recycling.
The waste generated during the disposal of the unit
is subject to mandatory collection and consequent
disposal in the prescribed manner.
For further information about recycling of this prod-
uct apply to a local municipal administration, a dis-
posal service or to the shop where you purchased
this product.
The manufacturer preserves the right to change
design, structure and specifications not affecting
general principles of the unit operation without a
preliminary notification due to which insignificant
differences between the manual and product may
be observed. If the user reveals such differences,
please report them via e-mail info@vitek.ru for
receipt of an updated manual.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appliance
was purchased. The bill of sale or receipt must be
produced when making any claim under the terms
of this guarantee.
This product conforms to the EMC Directive
2014/30/EU and to the Low Voltage Directive
2014/35/EU.

Related product manuals