ENGLISH
8
PROGRAMMED PLAYBACK
You can program playback of tracks (max. 20) at
the desired order.
1. Press the CD/SD/USB button on the unit and
select the media type: disc, memory card or
USB drive.
2. Press the PROG button once. The “PROG”
symbol and the “P01” symbol will be flashing
on the LCD-display.
3. Use the FOLDER UP / FOLDER DOWN but-
tons to select the desired folder
4. Select the track by pressing the or but-
tons.
5. To store the selected track press the PROG
button. The number of the track while pro-
gramming will change to “Р02”.
6. Repeat points 2-5 to program each of the
following tracks. You can program up to 20
tracks
7. To playback the programmed tracks, press
the PLAY/PAUSE button.
Note: To pause the programmed playback, first
press the STOP button and then press the PLAY/
PAUSE button.
To cancel programmed playback, press the
STOP button, or open the disc slot lid, remove
a memory card or a USB from the correspond-
ing jack, or set the FUNCTION switch to another
position.
AUX IN jack
To connect the external device, use the AUX IN
jack. Connect the external device using the au-
dio cable 3,5 mm Jack - 3,5 mm Jack (not sup-
plied).
TROUBLESHOOTING GUIDE
Improper usage is always the case of trouble. If you consider that there is something wrong with the
unit, check possible causes in this table.
If you have not managed to solve the problem, apply to the nearest authorized service center or to
the dealer for repair.
Problem Possible cause Solution
No sound
Zero level of volume Adjust volume level
No power Check the power supply
Improper operation of the
LCD-display
Electrostatic electricity
Switch off the unit and switch it on
in a while
3455IM.indd 83455IM.indd 8 18.12.2009 17:43:1618.12.2009 17:43:16
To Next Page
Loading...
