6
symbols “language” (12) will be flashing
on the display.
–
You can select the following languages
to indicate the days of the week: English
«ENG», Danish «DA», Spanish «SP»,
Dutch «DU», Italian «IT», French «FR»,
German «GE», select the language by
touching or touching and holding the but-
tons (4 or 9) “
”, “ ”, touch the button (5)
“
” to confirm. The current time and date
will be shown on the display.
Note: - if during setting the current time no
setting buttons are touched within 30 seconds,
the unit will switch to the default settings.
Alarm actuation time setting
–
This model of the weather station allows
using two alarms “
”. Before setting
the alarm actuation time make sure that
the current time is set correctly.
–
First alarm signal actuation time setting: –
touch the button (8) “
”, the preset alarm
actuation time (5), the symbols “AL” (2) and
the symbol “
” will appear on the display.
–
Second alarm signal actuation time set-
ting: – touch the button (8) “
” again,
the preset alarm actuation time (5), the
symbols “AL” (2) and the symbol “
” will
appear on the display.
–
Select the necessary alarm «AL1 or AL2».
–
Touch again and hold the button (8) “
” for 3 seconds, the digital symbols
of alarm actuation time “hours” will be
flashing.
–
Touch or touch and hold the buttons (4
or 9) “
”, “ ” to set the alarm actuation
time in “hours”, touch the button (5) “
”
to confirm, the alarm actuation time digi-
tal symbols “minutes” (5) will be flashing
on the display.
–
Touch or touch and hold the buttons (4
or 9) “
”, “ ” to set the alarm actuation
time in “minutes”, touch the button (5) “
” to confirm, the alarm actuation time
“
” is set.
–
Select the second alarm “ ” and set its
actuation time in the similar way.
–
To switch the alarm on in the current time
mode touch the button (4) “
”, the sym-
bols “
”, “ ” or “ ” will appear on
the display; select the necessary alarm.
–
To switch the alarm off in the current time
mode touch the button (4) “
” until the
symbols “
” go out.
Note: - if during setting the current time no
setting buttons are touched within 30 seconds,
the unit will switch to the default settings.
–
During the alarm signal you can touch the
button (11) “
” to temporary switch the
alarm off; the symbol «
» will be flash-
ing on the display, the alarm signal will be
switched on again in 5 minutes.
–
To switch the snooze function off touch
any button (3, 4, 5, 8, 9, 11), the flashing
symbol «
» on the display will go out.
Note: - the alarm sound signal will be
changing from single beeps to group sig-
nals, in 30 seconds the signal will sound
constantly.
Temperature measurement
unit selection «°С or °F»
–
To change the temperature measurement
units view press the button (9) “
”, the
temperature units (7, 10) «°С or °F» on the
display will change.
Weather forecast
–
Depending on the weather the following
weather forecast symbols (6) appear on
the display:
Sunny
Partly cloudy
Cloudy
Rain
IM VT-6412.indd 6 27.02.2018 16:44:44
To Next Page
Loading...
