EasyManua.ls Logo

Vitrifrigo ICE Maker - 2. DESCRIPTION OF APPLIANCE; 3. INSTALLATION; 4. ELECTRICAL CONNECTIONS

Vitrifrigo ICE Maker
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
12
2. DESCRIPTIONOFAPPLIANCE(SeeFig.1,3,4)
A) switch
B) icetray
C) icelevelindicator
D) tank (REFILLversiononly)
E) solenoidvalve (HYDROversiononly)
F) pump
G) frontpanel
H) waterlevelindicator(REFILLversiononly)
I) condenser
J) gridassembly
K) ller (REFILLversiononly)
L) refrigeratingsystem
M)Adjustmentthermostat
Thelabelthatshowstheserialnumberandtechnicaldataispositionedontheinside
oftheicemaker,inthetopleft-handsection.Therstfournumbersoftheserial
numbershowtheyearandweekinwhichthemachinewasbuilt.
3. INSTALLATION
Makesurethatthemachineisnotdamagedinanyway.Anydamagescausedduring
transportmustbecommunicatedto theretailerin duetimeand inanycase, no
morethan24hoursfromthetimeofdelivery.Handlethemachinewiththeutmost
careandattention.Alwayspositiontheicemakeronahorizontal,atsurface.The
icemakermustbepositionedinadryarea,wellawayfromanysourcesofheat.
Sufcientventilationmustalsobeguaranteedand,ifthemachineistobeboxedin,
twoopeningsmustbemadeinitscontainingunit:therstopeningmustbemade
incorrespondencetotheslitsonthefrontpanelI);thesecondopeningmustbe
alignedwiththefrontor-preferably-theupperpartofthefurnitureunit.These
openingsmustbe nolessthan 300sq.cm. Ifitis notpossibleto carryoutthis
operation,thenagapofatleast50mmmustbeleftbetweenthetopoftheice
makerandthesurfaceaboveit(seeFig.2).Leavethemachineidleforatleastone
hourbeforeputtingitintooperation.Duringthistime,itispossibletocarryoutthe
initialcleaningoperations.
4. ELECTRICALCONNECTIONS
Beforeconnectingthemachine,makesurethatthemainsvoltagecorrespondsto
thatgivenonthemachineorcompressorratingplates.
Thismachinemustbeearthedinaccordancewiththelawsinforce.Make
surethattheelectricalsystemearthinginstallationisinperfectworkingorder.
The manufacturer hereby refuses to accept any liability for damages to
peopleorpropertyarisingfromthefailuretorespectthisregulation.
The use of adapters, multiple sockets, or extension leads is not recommended.
Shoulditbenecessarytouseoneofthelatter,alwaysusematerialsthatconform
tothesafetystandardsinforceandtakecarenottoexceedthecurrentcapacity
limitsstatedonthematerialsthemselves.Intheeventthattheicemakerplugis
notcompatiblewiththesocket,itispreferabletoreplacethesocketwithanother,

Related product manuals