Vitrifrigo ICE Maker - 7.2. MAINTENANCE MODE

EN
14
Theice-makingcycleisasfollows:
−PRODUCTION
Thebaseofthegridassemblyislledwithwater
andthethermostatremainsintheopenposition.
Once the set temperature has been reached, the cycle for ice ejection from the
grid assembly (J) (~ 40 min.) will begin.
−EJECTION
1
Onceatthecorrecttemperature,thethermostatwillclose,
enablingtheheatingelementandthemotor.
2
Theextractorbladeswillpressontheiceuntilitdetaches;the
heatingelementremainsenabled.
3
Thebladesextracttheicecubesfromtheirseating,pouring
themintothetray(B).
The ice production cycle continues until the ice tray (B) has been lled or until the
water in the tank (D) has been used.
7.2.MAINTENANCEMODE
During maintenance operations, the ice-making operations are interrupted. At
thisstage,thethermostat(M)(seeg.1org.4)mustbeturnedtothe“ice
maintaining”position(seeg.1a).Thisthermostatsettingkeepstheicecubes
inoptimumcondition,evenforlongperiods.Duringthemaintenancestage,the
thermostatissettopreventtheformationofalayeroficeonthefrontsectionof
thetrayoronthefrontofthegridassembly,aswellasreducingicemakerpower
consumption.
Themachineentersmaintenancemodewhen:
− Thereisnowater(REFILLversion).Rellthetanktoresetthemachineto
ice-makingmode.
− Thetrayisfullofice.Emptythetray(evenpartly),torestthemachineto
ice-makingmode.
PLEASENOTE: Check the water level of the machine on a regular
basis, using the indicator (H), and pour in more water if necessary.
Insufcient water will lead to the production of ice being suspended
or to the production of irregular-shaped cubes, and may even cause
damage to the pump.