Vivax FS-41T User Manual

ENG VIVAX
7
ASSEMBLY AND INSTALLATION
First step: Assemble support parts
1. Assemble and connect the base with assembly up-down tube and
support tube.
2. Open the casing and take out base, then assemble the tube and
cover of up-down tube and support tube.
3. Aim the hole on the bottom of support tube of support at the holes
on the base and tighten the screws.
4. Slip decorative cover to base alongside the support tube and
adjust up-down tube to height, then rotate tighten the external joint.
Second step: Assemble fan blade
1. Assemble guard cover and shroud ring
a. Tighten back cover enclosure to the motor by fastener (Pay
attention to direction of rotation).
b. Place joint of shroud ring downwards and cover the deep
groove of shroud ring to the circle side ring of back.
c. Cover enclosure, then tighten the bolts at the position of joint
properly by nut.
2. Install fan blade
a. While installing fan blade, please wedge groove on the back
of fan blade on spacer pin of the output shaft of motor,
b. Tighten the fixing nut of fan blade anticlockwise.
3. Assemble front cover
a. Insert the circle of front cover into the groove of shroud ring,
which has been fixed to the back cover.
b. Finally fasten the bolts into screw of the joint of shroud ring.
FUNCTION INTRODUCTION
1. Setting of wind direction
The angle of the fan head is adjustable, it can be facing upwards
and downwards by slightly lift or press the cover.
2. Setting of shaking
Pressing the turning button and the head starts to rotate, then pull it
out and fan will stop rotating.

Vivax FS-41T Specifications

General

Type	Household blade fan
Airflow	2412 m³/h
Placement	Floor
Noise level	55 dB
Control type	Buttons
Fan diameter	400 mm
Product color	White
Auto oscillating	Yes
Number of speeds	3
Height adjustment range	123 - 127 mm
Power source type	AC
Power consumption (typical)	50 W

Weight and Dimensions

Height	1230 mm