5. Installation Instructions
After receiving the product, please carefully check it against the accessories list (see page
NO.35 for list of accessories), be careful during installation and assemble the bike according
to the following steps. Notice: Installation steps may be slightly different for different
models. Take the real object as the standard. Please find the installation steps for specific
models.
For your safety, please wear protective gloves before installation.
Improper assembly may present a risk of loss of control, bumping or falling. When
assembling the electric bicycle, please note to apply the appropriate force. Too tight or too
loose tightening may cause damage or failure of the electric bike. Special Note: Do not
assemble or repair it under power-on condition.
If you use non-allowable parts, wrong installation may result in damage to the electric bike
or even personal injury. Do not attempt to ride an electric bike that is not properly installed.
Do not disassemble or modify the electric bike by yourself without permission. Otherwise, it
may cause permanent damage to the electric bike and may also cause personal injury.
5.1 Installation of handle stem
Applicable to models MT20 / MT20-P / FM201 / FM201-P5.1.1
Note:
When adjusting the height of stem, please do
not exceed the limit line!
Insert the upper part of stem into its lower part, and lock the fixing structure in the
middle of the stem.
Vertically erect handle stem and lock the folding device at the bottom of handle stem.
Ensure that the stem structure has been fixed and the handlebars are free from shaking.
To Next Page
Loading...
