Vivint SmartHome Element V2 - Z-Wave and Thermostat Programs; Compressor Protection

45
Vivint Element Operation Guide
Product Overview
Z-Wave and Thermostat Programs
TheThermostatmustbeconnectedtoaZ-Wavenetworkinordertooperatethedevice
remotelythroughyourpanelorapp.UseyourZ-Waveapplicationtoadjusttheheating
andcoolingprogramsthattheThermostatusestorunyoursystem.Youcantemporarily
overridetargettemperaturesandchangesystemmodesfromthethermostat,butyou
mustusetheZ-Waveapplicationtomakepermanentchangestoprograms.
Compressor Protection
TheThermostathasaminimumcycletimeofve(5)minutestoprotectyourcompressor
fromexcessivewearfromrespondingtothermostatchanges.TheHomescreenshows
themessage“CycleDelay”.Thecompressorwillnotcomeonuntiltheve-minutedelay
isover.