EasyManua.ls Logo

Vivitar DRC-333 - Setup and Charging Procedures; Battery Insertion and Disposal

Vivitar DRC-333
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. A QUICK LOOK AT THE CONTROLLER
6. INSERTING BATTERIES
FORBIDDEN
Do not disassemble
FORBIDDEN
Do not disassemble
Battery lid
Use a screwdriver to open
the battery compartment.
Insert six AA batteries into the battery
compartment. Make sure the batteries are
inserted with the correct polarity (-,+) as
indicated in the battery compartment.
Step 1
Step 2
4
Power Switch
Left/Right Rotation Trim
Antenna
Single Eversion
Throttle
Throttle Trim
Directional Control Stick:
Forward/Reverse, Left/Right
Left/Right Roll trim
Pitch Forward/Reverse Trim
Speed: Slow 30%, Quick 60%, Fast 100%
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
Correct Disposal of this Product. This marking indicates that this
product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal,recycle it responsibly
to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the
retailer where the product was purchased to see if they can take this
product for environmentally safe recycling.

Related product manuals