5
Your helicopter has a built in 3.7V 1200mAh battery. Before charging your helicopter,
make sure that the ON/OFF switch is in the OFF position.
Unplug the charging cable from the helicopter’s receiving board, and connect it to
the included USB charging adapter.
Then plug the USB charging adapter into a suitable USB charging port.
An LED light on the helicopter’s circuit board will turn RED while the battery is
charging, and then turn green when charging is complete.
Once charging is complete connect the
charging cable back into the helicopter’s
receiving board.
6. Charging Your Helicopter’s Battery
WARNING:
1. Unplug the charger when charging is complete to avoid damaging the battery.
2. Do not leave the battery unattended when charging.
3. Do not use other chargers other than the one supplied.
4. Wait at least 30 minutes after using your chopper before charging the battery. The battery’s
temperature can become elevated during use and charging it immediately could damage the battery.
5. Do not leave the battery exposed to excessive heat, flame or fire.
ON
OFF
To Next Page
Loading...
