Vivotek FD9167-H - Page 369

VIVOTEK
User's Manual - 369
gettiltangle <integer> Get the current tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getzoom 0, <positive integer> Get the current zoom position.
getratio <decimal> Get the current zoom ratio.
getfocus 0, <positive integer> Get the current focus position.
getminspeedlv 0, <positive integer> Get the minimum speed level of the PTZ control. Normally, the speed
level is ‘0,’ which denotes halting a continuous movement.
getmaxptspeedlv 0, <positive integer> Get the maximum speed level of pan/tilt moving.
*Only available when "capability_camctrl_c<0~(n-1)>_buildinpt" > 0
getmaxzspeedlv 0, <positive integer> Get the maximum speed level of zoom moving.
getmaxfspeedlv 0, <positive integer> Get the maximum speed level of focus moving.
getminpan 0, <positive integer> Get the lower limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmaxpan 0, <positive integer> Get the upper limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getminpanangle <integer> Get the lower limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmaxpanangle <integer> Get the upper limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmintilt 0, <positive integer> Get the lower limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmaxtilt 0, <positive integer> Get the upper limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmintiltangle <integer> Get the lower limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getmaxtiltangle <integer> Get the upper limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is "1"
getminzoom 0, <positive integer> Get the lower limit for zoom position.
getmaxzoom 0, <positive integer> Get the upper limit for zoom position.
getmaxdzoom 0, <positive integer> Get the upper limit for digital zoom position.