Vivotek FD9366-HV - Page 265

VIVOTEK
User's Manual - 265
© 2019 VIVOTEK INC. All Right Reserved
130
NAME VALUE SECURITY
(get/set)
DESCRIPTION
Bit 1 => Capture video raw data
Bit 2 => Support encode jpeg
Bit 3 => Capture audio raw data
Bit 4 => Support event trigger
Bit 5 => Support license registration
Bit 6 => Support shared memory API
Bit 7 => Support digital signature of
package
Bit 8 => Support snapshot
vadp_npackage <positive integer> 0/7 Indicate the maximum number of
VADP package that can be uploaded
to the device.
camctrl_httptunnel
<Not support
anymore>
<boolean> 0/7 Indicate whether to support
httptunnel.
* Not support this parameter
anymore when the version number
(httpversion) is equal or greater than
0301b.
* It will be replaced by
capability_camctrl_ptztunnel.
camctrl_ptztunnel <boolean> 0/7 Indicate whether to support
ptztunnel.
* We support this parameter when
the version number (httpversion) is
equal or greater than 0301b.
This equals
"capability_camctrl_c0_ptztunnel".
* This is kept for compatibility.
camctrl_privilege <boolean> 0/7 Indicate whether to support “Manage
Privilege” of PTZ control in the
security page.
1: support both
/cgi-bin/camctrl/camctrl.cgi and
/cgi-bin/viewer/camctrl.cgi
0: support only
/cgi-bin/viewer/camctrl.cgi
© 2019 VIVOTEK INC. All Right Reserved
131
NAME VALUE SECURITY
(get/set)
DESCRIPTION
This is equivalent
to"capability_camctrl_c0_privilege".
* This is kept for compatibility.
uart_httptunnel <boolean> 0/7 Indicate whether to support HTTP
tunnel for UART transfer.
transmission_mod
e
Tx,
Rx,
Both
0/7 Indicate transmission mode of the
machine: TX = server, Rx = receiver
box, Both = DVR.
network_wire <boolean> 0/7 Indicate whether to support Ethernet.
network_wireless <boolean> 0/7 Indicate whether to support wireless.
network_dualmod
e
<boolean> 0/7 Indicate whether network dual mode
is supported.
* Only available when
"capability_network_wireless" is "1".
* We support this parameter when
the version number (httpversion) is
equal or greater than 0305a.
wireless_s802dot1
1b
<boolean> 0/7 Indicate whether to support wireless
802.11b+.
wireless_s802dot1
1g
<boolean> 0/7 Indicate whether to support wireless
802.11g.
wireless_s802dot1
1n
<boolean> 0/7 Indicate whether to support wireless
802.11n.
wireless_begincha
nnel
1 ~ 14 0/7 Indicate the begin channel of wireless
network
wireless_endchann
el
1 ~ 14 0/7 Indicate the end channel of wireless
network
wireless_encrypt_
wep
<boolean> 0/7 Indicate whether to support wireless
W E P.
wireless_encrypt_
wpa
<boolean> 0/7 Indicate whether to support wireless
WPA.
wireless_encrypt_
wpa2
<boolean> 0/7 Indicate whether to support wireless
WPA2.
wireless_apmode_
enable
<boolean> 0/7 Indicate whether wireless AP mode is
supported.