Vivotek FD9366-HV - Page 397

VIVOTEK
User's Manual - 397
© 2019 VIVOTEK INC. All Right Reserved
262
8.32 Connect to AP (capability_network_wireless > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/connect_ap.cgi
PARAMETER VALUE DESCRIPTION
N/A N/A Apply the wireless settings and connect to AP.
8.33 Get Wireless Information (capability_network_wireless >
0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/getwirelessinfo.cgi
PARAMETER VALUE DESCRIPTION
N/A N/A Get wireless information. Camera will return following
information.
1. Wireless channel
2. Link quality
3. Signal level
4. Noise level
5. SNR
6. TX Rate
7. RX Rate
© 2019 VIVOTEK INC. All Right Reserved
263
8.34 Get Wireless Signal Strength (capability_network_wireless
> 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/getwlsignalstrength.cgi
PARAMETER VALUE DESCRIPTION
N/A N/A Get wireless signal strength.
8.35 WPS Transaction (capability_network_wireless > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/start_wps.cgi
PARAMETER VALUE DESCRIPTION
N/A N/A Start WPS transaction.