Revison History:
Rev. 1.0: Initial release
VIVOTEK FD9367-HTV (EPOC)
Installation Guide
Installation
II
5mm
Attach the included alignment sticker to a preferred position. Drill
holes on the wall and if space behind the wall allows, you may also
pass cables through the wall.
Open the top cover using a T10 L wrench.
Keep for later use
Open the included rubber seal grommet and pass the BNC
cable throught it (female to right-angle male BNC connector
cable).
There are two cable routing options:
A
. through the bottom hole.
B
. through the M20 conduit hole on the side.
x3
1
2
5
A-1
Package Contents
Leave 5mm of screw thread above the wall. This ensures easier
installation using the camera's keyhole slots.
3
Loosen the 3 T10 screws to remove the camera.
Remove the original rubber
seal by loosening 3 T10
screws. Push the seal apart
from the bracket.
A-2
Press the rubber seal assembly into place, and tighten the 3 T10
screws.
x3
A-3
If routing through an M20 conduit, remove the plug and install the
conduit. Route an RG6 coaxial cable through it. The M20 conduit is
user-supplied.
B-1
Loosen the 2 screws securing the AP-FEX-0105-T EPoC module.
Lift it up a bit so that you can connect the BNC connector.
5
Make sure the split on the seal grommet is on the outer side.
Move to Step 5
5
Move to Step 5
Connect the male connector on the cable to the counterpart on the
module. When done, secure the module back in place.
RG6 100m ~ 2.4km
AP-FEX-0105-T
EPoC Tx Module
PoE switch
AP-FEX-0105-R
EPoC Rx Module
RG6 100m ~ 2.4km
AP-FEX-0105-T
EPoC Tx Module
Network switch
AP-FEX-0105-R
EPoC Rx Module
UPoE Injector
Applications
Distance/Power Chart
AP-FEX-0105-T
Length of Coaxial Cable AA-420 65W AP-GIC-011A-095 95W
300m 26.4W 26.4W
500m 17.48W 17.48W
800m 12.63W 12.63W
1000m 8.84W 8.84W
1200m 8.48W 8.48W
1200m ~ 2400m Data only (100Mbps) Data only (100Mbps)
AP-FEX-0200-T
Length of Coaxial Cable AA-420 65W AP-GIC-011A-095 95W
100m 20W per port 20W per port
300m 12W per port 12W per port
500m 8W per port 8W per port
500m ~ 2400m Data only (100Mbps) Data only (100Mbps)
6
M20
Seal ring x 2
Use 2 seal rings when installing the conduit.
B-2
0002D10766AD
XXXXXX
Jot down the camera's MAC address for later reference.
4
To Next Page
Need help?
General
